How To Clean Primo Water Dispenser Drip Tray


Take some paper towel lightly dab into water. There are 15 simple steps to cleaning your primo water dispenser:

Best dispenser for your home and office Water dispenser

Table of Contents

Lift off the drip tray.


How to clean primo water dispenser drip tray. 10 best bottom loading water dispensers the best on the market. Underneath the drain is the drip pan where the water gathers and eventually evaporates. Insert probe assembly into bottle.

Take the top apart and remove all components. Place tray and cover in dishwasher or wipe parts clean with a soft cloth and warm soapy water. Visit to find primo water at a store near you.

If you’re more of a visual learner, check out the process below: Install water bottle bottle not included. There is an insert in the dispenser drip tray.

Take some paper towel, lightly dab into water. Grab a bottle of primo® water (sold separately) and fully remove the cap. Remove drip tray and scrub clean.

The drip tray and grill should be cleaned monthly. As of our highest quality pick bottom load bottled water dispenser hot cold fountain bottom loading water new is a splendid beginning it gives most of the features with an exciting price. Slide drip tray into place.

Clean the drip tray and grill by emptying the tray and cleaning the tray and grill with dishwashing soap or by placing them on the top rack of the dishwasher (fig 7). (visit for detailed cleaning instructions.) place probe assembly on hanger inside door to keep it clean. Use a soft, clean cloth or paper towels to dry the exterior surfaces.

A ground fault interrupting receptacle. Small droplets of water fall into the tray, and they sit there unnoticed, allowing bacteria growth. Deposits, use only high quality purified bottled water such as primo.

Slide drip tray assembly into position until it is secure. Unplug the power cord from the wall outlet. Move appliance away from the wall to gain access to the back.

Allow the cleaning solution to fill the reservoirs. Unpack drip tray and insert into dispenser.unplug the power cord from the electrical outlet.using the sponge, give the drip tray and water taps a thorough scrub and rinse with clean water. (visit for detailed cleaning instructions.) place probe assembly on hanger inside door to keep it clean.

Remove remaining water from reservoirs by dispensing from the hot and cold taps into a pitcher or bucket. Primo water dispenser compressor not working primo water dispenser cooling problems. Apply the cleaning bottle to the dispenser.

Remove drip tray and grid from protective packaging. Be sure you dry thoroughly such that you will not leave any moisture in the tight spaces. Wait 10 minutes then drain the water from the reservoirs as described in step 5.

If cold water is still not cold, try these other troubleshooting instructions: This should be enough, but you might have to repeat this process with clean water until water no longer has any taste of cleaning solution. Pour the bleach (2 tbsp.) or vinegar (2 cups) and hot tap water (2 gallons) into the empty bottle.

Replace parts and plug in. How much electricity does a primo water dispenser use? Clean bottle cap and neck with a cloth and warm soapy.

Clean the water drip tray. Besides, remember to clean dispenser's screen. Visit to find primo water at a store near you.

Primo water dispenser troubleshooting and how to fix your system. It takes up to one hour after setup to dispense cold water. Also know, how do you clean a primo water dispenser?

Primo water purification process a foodie stays fit. Wipe over the taps and drip tray with the paper. How to clean a bottom load primo water dispenser primo hot, cold, and room temperature top loading water dispenser review affordable products always attract customer easier compared to the pricey ones.

Apply the cleaning bottle to the dispenser. To keep probe assembly clean. Make sure the power cord is properly connected to a working outlet.

Clean probe with a damp cloth and dish soap. Remove drip tray from door and place the g rid on top. Primo water cooler drip tray.

Avoid health risks know how to clean a bottom loading water cooler. Free shipping on eligible orders. How to clean primo water dispenser.

Clean the water drip tray. If i calculate correctly, then at $2.00 per day, what you are saying is that your electricity consumption for using the primo water dispenser costs approximately $60.00 per month. Requires standard 11.3 to 18.9 litre water dispenser bottles.

Take the water dispenser out of the fridge and place it on a protected surface. Wipe down the cooler and the surrounding area to dry any water spills. The drip tray of your water dispenser holds more bacteria than any other portion of the dispenser.

How to clean primo water dispenser drip tray. Allow the cleaning solution to fill the reservoirs. You should clean your drip tray at least once a week to make sure that all bacteria are removed before it becomes hazardous to your family’s health.

Primo water dispenser drip tray replacement.

Pin on Water Dispenser

Pin on Water Cooler and Dispenser

Pin by Jan Wandrag on Office Wall lights, Home decor, Decor

Pin on Top 10 Best Water Cooler In 2018 Reviews

Pin by Nicole Kennedy on II Staging II Outdoor decor

Tags: , ,

Leave a Reply

Your email address will not be published.

Related Post